Connecting Ring Alarm Pro Cams/Doorbells with Ring Edge

Ring Video Doorbells or Cams linked to your Ring Alarm Pro can be connected to process and store videos locally on a microSD card through Ring Edge. To do this, your Ring Alarm Pro and Ring cameras and doorbells must all be on the eero network from your Ring Alarm pro.

Turning on Ring Edge

1. During the initial Ring Alarm Pro setup, you’ll see an

   Activate Ring Edge

    screen.
2. Tap

   Get started.
3. If you already have Ring cameras installed, they will be displayed on screen. Make sure they are on the eero network to connect to Ring Alarm Pro’s local video and processing.
4. For cameras you want for local processing and storage, tap the toggle to turn this feature on.
5. If you do not already have Ring cameras installed, you can always go back to Ring Alarm Pro, then tap on

   Enrolled Cameras

   to opt cameras into local processing and storage once your cameras are set up.

To turn on Ring Edge after installation:

1. Tap

   Ring Alarm Pro.
2. Tap

   Device Settings.
3. Tap

   Enrolled Cameras
4. Make sure your cameras are on the eero network to connect to Ring Alarm Pro’s local video and processing.
5. For cameras you want for local processing and storage, tap the toggle to turn this feature on.

To turn off local processing and storage:

1. Navigate to the Ring Alarm Pro settings page.
2. Tap

   Enrolled Cameras.
3. Toggle off any cameras you wish to no longer use for local processing and storage.