How to Physically Install Your Ring Video Doorbell (2020 release) With an Existing Doorbell

Physically installing your Ring Video Doorbell (2020 release) with an existing doorbell is a simple process. Simply scroll down for a step-by-step guide.  

You should set up your Ring Video Doorbell in your Ring app before mounting it to your home.

Click here for information on setting up your Ring Video Doorbell (2020 release) in the Ring app. 

Step One: Charge the built-in battery

  • Fully charge the built-in battery by plugging it into a USB power source using the provided orange cable.
    • When only one of the two LEDs on the battery is lit, the battery is fully charged. 

Click here for more information on charging your Ring battery.

Step Two: Remove your existing doorbell

If replacing an existing doorbell, shut off power to your doorbell system at the breaker. Then remove the doorbell button from the wall and disconnect the wires.

f wiring your Ring Doorbell to an existing doorbell, a transformer with a voltage of 8-24 VAC, 40VA max, 50/60Hz is required. 

DC transformers and most intercoms are not supported.

WARNING: Electrical shock hazard. Disconnect power to installation area at your circuit breaker or fuse box before beginning installation. Always use caution when handling electrical wiring.

Installation by a qualified electrician may be required in your area. Refer to your local laws and building codes before performing electrical work; permits plus professional installation may be required by law.

Step Three: Line Up your Ring Video Doorbell (2020 release) 

To properly line up your Ring Video Doorbell: 

  • Place the Ring Doorbell next to your door at about 48 inches from the ground. 
  • Level the device using the level tool. 
  • Mark the positions for mounting holes with a pencil. 

Step Four (Optional): Drill the mounting holes (Only When Mounting on Brick, Concrete, or Stucco)

If you’re mounting on wood or vinyl siding, you can skip this step.

  • Use the included drill bit in a power drill to drill holes at the positions you marked.
  • Insert the included plastic anchors into the holes. You may need to use a hammer to get the anchors in. 

Step Five (optional): Attach the wire extensions.

If you have trouble connecting the wires coming out of the wall to the back of your Ring Video Doorbell, use the provided wire extensions and wire nuts.

Step Six: Connect the wires

Connect the wires coming out of your wall to the provided screws on the unit.

Either wire can connect to either provided screw. The order doesn't matter.

Step Seven: Put Your Ring Video Doorbell in place.

Place your Ring Video Doorbell over the holes.

Step Eight: Screw in the Ring Doorbell 

Feed all the wires (and the wire nuts if you used them) into your wall and secure your Ring Video Doorbell on the wall. Be sure you use all four included screws. 

Step Nine: Install the Security Screw

Use one of the provided security screws and the star-shaped end of the screwdriver bit to secure the faceplate.

rvd-2nd-gen-sec-screw-comp.jpg

Note: For your safety, use only the short security screws under the faceplate. Using any other type of screw could damage the battery and create a potential fire hazard.

Click here for information on setting up your Ring Video Doorbell (2020 release) in your Ring App.

 

Join Our Community

Share feature requests, get help, and discuss the latest in security with your fellow users on Ring's first neighbor-to-neighbor community forum.

Was this article helpful?

×

 

 



Send Feedback