Uninstalling the Peephole Cam

Uninstalling your Peephole Cam is as simple as installing it. Simply scroll down for a step-by-step guide.

Remove the Battery Cover

  • Remove the battery cover from the indoor portion of the Peephole Cam by pinching it from both sides and pulling it towards you. The cover should pop right off without any force being applied.

Remove the Battery

  • Slide the battery out of the bottom of your Peephole Cam.

Remove the Connector

  • Gently grasp the plastic connector on the end of the cable and remove it from the connector port.

Note: The cable is fragile, so be careful not to bend it too much or tear it when removing it from the connector port.

Click here for information on what to do if the cable breaks.

Unscrew the Tightening Nut

  • Unscrew the tightening nut counter-clockwise in your peephole using your fingers or the tool that came in the box.
  • Grasp the indoor assembly and gently pull it away from the door. Be sure to hold the other side of the assembly in place to keep it from falling out.

Note: Be careful of the cable as you remove the indoor assembly and help it slide gently through the hole in the assembly so as not to damage the cable.

Remove the Outdoor Half

With the indoor side removed, the outdoor portion should slide right out.

Note: The cable is fragile. Be careful not to catch it on anything when sliding the outer portion out of the door

Remove the Adapter (if you installed it)

Replace the Original Peephole

Replace the original peephole in the hole in the door. Use your finger to screw in the peephole clockwise as far as it will go. If you don’t have your original peephole you can pick one up at your local hardware supplier. If you used the adapter, you will need a 9/16" (~14mm) viewer. If you don't have your old peephole, your local hardware supplier may have a compatible one. Measure the hole diameter and your door's thickness and check these with your hardware supplier if you're not sure what will be compatible.

Once that's done, place the flat edge of the Peephole Key into the slots on your peephole and rotate clockwise to screw it in. If you don’t have the Peephole Key, you can use a large flathead screwdriver or another flat tool.

Join Our Community

Share feature requests, get help, and discuss the latest in security with your fellow users on Ring's first neighbor-to-neighbor community forum.

Was this article helpful?




Send Feedback