How to Factory Reset Your Ring Alarm Devices

If you ever get stuck while troubleshooting your Ring Alarm devices and need to factory reset any of them (as a last resort), you can use the instructions below:

Contact Sensor (1st generation)

Contact Sensor (2nd generation)

Motion Detector (1st generation)

Motion Detector (2nd generation)

Keypad (1st generation)

Keypad (2nd generation)

Range Extender (1st generation) and (2nd generation)

Factory Reset your Base Station:
Do not attempt to factory reset your Ring Alarm Base Station without guidance and support from a trained Ring Customer Support expert. Please contact Customer Support for assistance if you're having difficulty with your Ring Alarm.

Factory Reset your First Alert Smoke & CO Detector
If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. NOTE: The device will not remain awake after resetting and will go into standby mode.

Factory Reset your Flood & Freeze Sensor
Press and hold the setup button (located on the side of the device) with the battery in, until the LED stops flashing (approximately 10 seconds).

Factory Reset your Panic Button
Press and hold the setup button (located on the side of the device) with the battery in, until the LED stops flashing (approximately 10 seconds)

Factory Reset your Dome Siren
Press and hold the Connect Button (located on the side of the device) for 10 seconds until the LED Ring blinks once, then release the button.

Join Our Community

Share feature requests, get help, and discuss the latest in security with your fellow users on Ring's first neighbor-to-neighbor community forum.