How to Connect Your Ring Video Doorbell Directly to a Low Voltage Transformer (Without a Pre-existing Doorbell)

Question: I would like avoid charging my battery by directly connecting my Ring Video Doorbell to a transformer. Is this possible and how do I do it?

Answer: Yes. If you don't have an existing doorbell, it's possible to connect a Ring Doorbell directly to a low voltage 8-24V AC transformer.

Note: Some important facts for people planning on using this optional alternate configuration for their Ring Video Doorbell. 

  • The Ring Video Doorbell can only be connected to an AC transformer. DC is not supported.
  • Connecting the Ring Video Doorbell to an AC transformer requires some knowledge of wiring and soldering. If you are uncomfortable reading wiring diagrams, hooking up wires or soldering them in place, consult a licensed electrician for assistance or use the built-in rechargeable battery to power your Video Doorbell.
  • Wires should be soldered onto the resistor and a wire clip can be used on the other end. 
  • In addition to the equipment included in your Ring Video Doorbell box, You will need to purchase an electronic resistor. A resistor is REQUIRED in place of a mechanical or electronic doorbell kit for this alternate configuration to work successfully.
  • Do NOT install a diode.

 

rvd2_direct_to_transformer_720.png

If you are looking to purchase a resistor, here are two we have tested and recommend:

 

Was this article helpful?
1003 out of 1430 found this helpful

Send Feedback