Setting Up Your Ring Spotlight Cam Wired In Your Ring App

Setting up your Ring Spotlight Cam Wired in the Ring app is a simple process.

Note: You must complete the Ring App setup prior to physically installing your Ring Spotlight Cam. For more information on physically installing your Spotlight Cam:

Click here for information on doing a Spotlight Cam wired installation.

 

Step One - Download the Ring App

 

To download the Ring App:

  • On your mobile device, go to the App Store.
  • Do a search for “Ring.”
  • Download and install the Ring app on your mobile device.
Step Two - Create or Login to Your Account

 

If this is your first Ring product, You will be asked to set up an account. To set up an account:

  • Open the Ring App.
  • Select Set Up a Device.
  • Follow the in-app instructions to create a new account.

If you already have another Ring product installed, simply open the app and select “Setup Device.”

Step Three - Tap “Setup Device’

 

  • Tap “Setup Device.”
  • Select Ring Floodlight Cam.
Step Four - Name Your Device

 

After beginning the setup process you will have the opportunity to name your Spotlight Cam to distinguish it from the other Ring products in your account. Several default names are suggested or you can enter a custom name for your Spotlight Cam.

Step Five - Specify Your Location

 

In the next step, if this is your first time setting up a Ring product, you will get a request from your phone informing you that the Ring App wishes to use your phone’s location services to pinpoint your location. Allowing the app to do so will assist in inputting your address. Without a specific location, certain features of your Spotlight Cam will not work properly.

Note: The app will estimate your address as closely as possible. If it is not completely accurate and misses the address by a few numbers, the app will still work properly.

Step Six - Put your Spotlight Cam into Setup Mode

 

If you just wired your Spotlight Cam and connected it to power for the first time, the bottom light will flash as the device goes into setup mode. 

If the bottom light is not flashing, you'll need to press and release the Setup button.

On the wired version of the camera, this button is on top of the unit closer to the right hand side.

 

Step Seven - Wi-fi Setup

 

For the next step, your phone or tablet will need to connect to the Wi-Fi network called “Ring Setup.”

If you’re on an Android device, this step should happen automatically. 

On an iPhone or iPad, follow the instructions below:

    • Press the Home button on your iPhone or iPad to leave the Ring app.
    • Navigate to the “Settings” app.
    • Tap “Wi-Fi.”  
    • Select the network from the list that begins with “Ring Setup.”
    • Close your Settings App and return to the Ring App.
    • When you return to the Ring app, the app will automatically scan for available Wi-Fi networks. Select the network closest to your Spotlight Cam to connect it.

The remainder of the setup should complete automatically. If it doesn’t or if you run into any problems, click here.

Note: Following setup, your Spotlight Cam may update its internal software. While performing an update, the bottom light will flash. While the update is taking place and the bottom light is flashing, your Spotlight Cam will not work. Wait until it completes and your light is glowing steadily before proceeding to the next step.

Step Eight - Run a Test Through Your Spotlight Cam 

 

Once your Spotlight Cam has completed its update and setup, return to your app and use the app controls to test your camera and floodlights as well as adjust your Motion Zones.

Was this article helpful?
21 out of 48 found this helpful

Send Feedback