Ring products though, (with the exception of Ring Video Doorbell Pro) requires a 2.4 GHz wifi network to function properly.
Connecting to hidden networks
Modems and routers can be configured to broadcast "hidden" networks in which
Check your wifi channels
Like a television, your modem or router broadcasts your wifi network on one of 13 "channels" in order to separate different wifi signals and send them to separate devices. Ring products can only connect to channels 1-11 on a 2.4 Ghz network. A network on channel 12 or 13, (commonly used outside the United States) does not show up on the list of available wifi networks. If you are using channel 12 or 13 consult your router guide to switch to a different channel.
In addition, most modems and routers are automatically configured to switch channels in order to get the fastest signal possible. If your modem or router has been locked to a particular channel, consult your manual on how to set it to automatically scan for open channels.
Resetting your modem or router
If you're still not able to successfully complete a setup, try rebooting your modem and/or router. Since your router and modem are usually the hardest working devices in your house, the devices like to be rebooted about once a month for optimal performance.
To reboot these devices, follow the instructions below:
- Unplug your router or model from its power supply (don't just turn it off).
- If your router and modem are separate, unplug both of them.
- Wait at least 30 seconds, then plug them back in.
- Wait for your internet to be restored.
Confirm that your internet has been restored by connecting another device to your wifi network and trying to access a website, then repeat the setup process.
Connecting to roaming networks
If you have a roaming network with multiple access points, and you're unable to successfully set up your Ring device, try disabling all but one of your access points. Then try repeating the setup process.
If setup succeeds when you have only one access point enabled, then the multiple access points are likely the cause of your setup issues. In this case, your best bet is to refer to the documentation that came with your access points for further troubleshooting.