The LED light on the front of your Ring Video Doorbell Pro or Ring Video Doorbell Pro 2 indicates the status of your doorbell. A solid white light means it's either in idle mode or recording.
|Example||Flashing Light Pattern||Activity|
|LEDs around the button spin blue||Ordinary button press|
|LEDs around the button spin white||Attempting to set up wifi when the device doesn't have any saved wifi credentials. Times out after 10 minutes.|
|Blue light moving upwards||In the process of connecting to network during setup|
|White light flashing on and off||Firmware update in progress|
|Blue circle is flashing, one second on, one second off||Device is booting up|
|Solid blue light||The speaker has been enabled|
|LEDs flash four times||
Successful set up.
Note: It can take up to an hour for Ring Video Doorbell Pro to fully power on upon first installation.
|Flashing white light at the top of the circle||Setup failed - password error|
|Flashing white light at the right of the circle||Setup failed - couldn't connect to Ring network|
|Flashing white light at the left of the circle||Setup failed - another reason|
|Short rapid flashing burst of blue light, followed by a spinning white circle||Factory restore|
|Top half blue flashing||During setup - incorrect password / after connection to power - device is charging|
|Bottom half red flashing||Device is not receiving enough power|