Note: This article applies to the Ring Video Doorbell (1st Generation). The latest Ring Video Doorbell (2nd Generation) doesn't require an additional diode.
Installing your Ring Video Doorbell is a simple process. This article will give you a step-by-step guide.
Note that you should set up your Ring doorbell in your Ring app before mounting it to your door. Click here for information on setting up your Ring doorbell.
1. Remove your old doorbell button
Note that this step is optional.
2. Line up the mounting bracket
To properly line up the mounting bracket:
- Click the level tool (included in the box) into the mounting bracket.
- Place the mounting bracket next to your door at about chest height.
- Level the mounting bracket using the level tool.
- Mark the positions of the for mounting holes with a pencil.
3. Drill holes
- Use a drill to drill holes where you marked the position of the mounting holes.
- If you are mounting the bracket on brick, concrete, or stucco put the included plastic anchors into the holes. You may need to use a hammer to get the anchors in.
- If you are mounting the bracket on wood or vinyl, just use the included screws.
4. Remove the level tool from the mounting bracket
5. Connect your doorbell wiring to the terminal screws located on the mounting bracket.
Note that this step is optional.
6. If your doorbell is digital, install the included diode.
Not sure if your doorbell is digital or mechanical or how to install the diode? Click here for information on using the included diode.
7. Place your Ring Video Doorbell on the mounting bracket.
Don't be afraid to use a little force.
8. Tighten the security screws
There is a tool included in your box that can be used to tighten the security screws.
Click here for information on setting up your Ring Video Doorbell in the Ring app.